BJSC Flow Control Valve, Flow Control Regulator | Nickel Plated Brass Push in Fitting
BJSC nickel plated brass push in fitting flow control valve (flow control regulator) provides accurate flow regulation for precise speed control of pneumatic cylinders as well as gas flow in severe conditions (temperature, sparks, abrasion, etc.). Nickel plated brass push in fitting flow control valve (flow control regulator) is made of nickel-plated brass for durability and corrosion resistances. Flow control valve (flow control regulator) nickel plated brass push in fittings can be used with a variety of tubing materials. To release the tubing, press the circular release ring and the tubing can be easily pulled out. Accommodate metric tubing O.D ranging from 4 mm to 12 mm and inch tubing O.D 1/8" to 1/2". Thread sizes of flow control regulator range is from BSPT, BSPP, NPT 1/8 to BSPT, BSPP, NPT 1/2. Control-out and control-in flow control valves (flow control regulators) are available.
Control-out flow control valve controls the flow rate of air entering from the thread side can be controlled, whereas air entering from the tube side comes out from the thread side at the same (not controlled) flow rate.
Control-in flow control valve controls the flow rate of air entering from the tube side can be controlled, whereas air entering from the thread side comes out from the tube side at the same (not controlled) flow rate.
Fluid Admitted: Air, Vacuum, Water (no freezing), Steam
Thread Size: From BSPT 1/8 to BSPT 1/2; 10-32 UNF to 1/2 NPT
Body Material: Nickel Plated Brass
Thread Material: Nickel Plated Brass
Sealing: NBR
Working Pressure: 0—2.0 MPa | 0—290 psi
Proof Pressure: 3.0 Mpa | 435 psi
Negative Pressure: -100 Kpa | -29.5 In Hg
Working Temperature: -20～150°C | -4～302°F